MEYERTECH DIVISION
ISSUE 01
4.
INSTALLATION
To obtain the optimum performance from your ZoneVu
system, please take time to read this manual
before commencing installation. If you have any questions or problems our staff will be pleased to
assist you on the technical help line listed on page 16.
WARNING
EQUIPMENT POWER SUPPLY UNITS CONTAIN HAZARDOUS
VOLTAGES. THE EQUIPMENT MUST BE EARTHED TO
PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE THIS
EQUIPMENT TO RAIN OR MOISTURE.
This ZoneVu interface should only be used in conjunction with the following equipment:
•
ZVM-328 3u 19” Low Profile Case (1 required per bank of 32 Domes).
•
ZVM-PSU Matrix Power Supply 12V (1 required for each ZVM-328 module).
•
DVK-001 Keyboard (1 required per system).
•
DVK-PSU 12V DC Keyboard Power Cube.
•
Star Micronics MD-200 Series Dome Cameras
4.1 CONNECTING THE TELEMETRY DISTRIBUTION
Connect up the telemetry distribution in accordance with diagram below and the specifications in
Section 7, paying special attention to the maximum ratings and the notes below.
1. ALWAYS use Screened cables for low voltage and signal cables, ensuring the screen is
connected to 0V or Earth.
2. AVOID looming cables of differing characteristics together E.G. Telemetry cables with cables
carrying mains power.
3. The maximum cable run for Twisted Pair is typically 1Km.
4. The maximum number of Dome cameras that can be connected to a driver interface is 31.
5. The domes should be ‘Daisy Chained’ with the last dome in the chain having it’s termination
switch set to ON, and all other domes unterminated.
Page 4
MAN-GW1-STR
http://www.meyertech.demon.co.uk
