C9154 Installation - pg. 6
»
F
ront
B
Umper
11.
If equipped, disconnect the fog light wires from the light housings mounted in
the front bumper
Figure 8
.
12.
Remove the bolt (on each side) mounting the outside bumper support to the
bumper. Remove the bolts mounting the support to the frame and remove the
support
Figure 8
. Save the supports and hardware.
Figure 8
13.
Since the grill was removed, the four inside bumper bolts (two on each side)
can be accessed from above the bumper
Figure 9
. While supporting the bumper,
remove the four bolts and separate the bumper from the vehicle. Save bumper
mounting bolts.
Figure 9
14.
Locate the wire loom running along the bottom of the core support
Figure 10
.
Remove the wire loom from the retain clips (approximately 4 total) and remove
the clips from the core support. The clips will not be reused. Be sure that the
lower portion of the fan shroud lip is clear from the bottom edge of the core sup-
port so it is able to drop while the body is lifted. If the vehicle is equipped with a
front skid plate, removing the skid plate will aid in accessing the clips.
