F2302 Installation - pg. 3
Figure 1
6.
Support the knuckle assembly so that the CV shaft and ABS / brake lines are not
overextended when removing the UCA.
7.
Remove the upper ball joint nut.
Figure 2
8.
Using an appropriate separator, dislodge the upper ball joint from the steering
knuckle
Figure 3
.
Figure 3
Step 7 Note:
Use the hex holding feature to
prevent the stud from turning while
removing the nut.
Step 8 Note:
Special service tool OTC 204-592
is recommended to dislodge the
ball joint taper.