ZOLL Propaq M, Руководство по обслуживанию

Страница: 48 / 78

44 9650-0804-01 Rev. A
Disassembling the Main Unit
Tool Required
•
# 1 Phillips screwdriver with torque capability
•
orange (wooden) stick
Setup
•
This procedure should be conducted on a static mat.
•
Wear a wrist strap to ground during the procedure.
•
Complete “Removing the Handle” on page 43 before performing this procedure.
To reassemble the main unit, reverse the steps.
Main Unit Disassembly
1 Place tape on the top of the unit (near the
front of the display) in the illustrated area.
2 Gently place unit screen so the display
screen is facing down.
3 Remove ten (10) screws: four (4) on the
top, four (4) on the bottom, and two (2) in
the middle in the illustrated areas. Take
care to keep the two parts of the unit
together.
Note: During reassembly, torque screws to
6 in-lbs.
4 While holding the two parts of the unit
together, place the unit vertically on the mat
(feet down).
5 Separate the top part of the unit by creating
a small gap, and remove any screws that
are in the way.