17
Remarks:
Only after the display output test, can the user perform the test on other functions.
5
）
Press
&
to change the program code of the function test. The function stood by
each code is shown in the following table:
6
）
Hold
to have access to the function test.
7
）
During the function test, if user presses
, the test will be stopped and the system will return
to the status of 5); However, if the continuous mode has been used for once, the test will be
unable to be released. For ending the test, the user can only turn off the power.
2.4.1 CP-1
（
Input Signal Test
）
Test the input status of the buttons, pedal and sensors. Press
to have access to CP-1
when the “CP-1” is displayed at the screen. After that, the screen displays the “1” that means the
first test content.
Function Test Code
Function
Content
Test input signal
LED hint switch, sensor input
X/ Y Motor Origin Sensor
Test
Display the statuses of the X/Y motor step
motion operation, origin searching operation
and X/Y origin sensor.
Continuous Running
If setting the condition of continuous running,
test the continuous running mode.
Main motor rotation
number test
Setting rotation number, machine
start-up ,display of actual rotation number
thread-trimming test
Action of thread-trimming motor, debugging
the installation of knife
Presser /thread-trimming
motor /origin sensor test
Display the step motion of
presser/thread-trimming motors, operation of
origin searching, and the status of presser
origin/presser sensor.
Thread-catching
motor/origin sensor test
Display the step motion of thread-catching
motor, operation of origin searching and the
status of thread-catching
origin/thread-catching sensor.
_________________ _________________