4
© Copyright 2014 Zoeller Co. All rights reserved.
CONDITION
pOSSIBLE CaUSE
REMEDy
a. pUMp WILL NOT STaRT OR RUN
Low voltage, blown fuse, open circuit
Have a qualified electrician check fuse and circuit.
Impeller bound
Contact a Zoeller Service Station.
Motor or wiring shorted
Debris on float switch
Remove debris.
B. pUMp STaRTS TOO SOON
Float “ON” point is adjusted too low
Raise the float stops, make sure the float is between the two stops.
C. WaTER LEVEL EXCESSIVE BEfORE pUMp TURNS ON
Float “ON” point adjusted to high
Lower the upper float stop.
D. pUMp WILL NOT SHUT Off OR RUNS TOO LONg BEfORE
WaTER IS pUMpED
Debris under float
Remove debris from around float.
Faulty float switch
Contact a Zoeller Service Station.
Float “Off” point adjusted too low
Raise the lower float stop.
Pump is air locked
Make sure vent hole in discharge pipe is clear.
Water level too low
Raise the lower float stop.
Waste material has accumulated blocking flow of material
to pump intake.
Hold flush handle down on toilet for 15 seconds. If unit will not
clear, unplug and wait 30 minutes. Plug unit back in and repeat.
If unit still will not turn off, it will need to be opened and the
debris relocated.
E. pUMp OpERaTES BUT
DELIVERS LITTLE OR NO WaTER
Debris around intake
Clean area around intake.
Blockage in discharge pipe
Remove pipe and flush out debris.
Low or incorrect voltage
Have a qualified electrician check house wiring.
Damaged Impeller
Contact a Zoeller Service Station.
Incorrect float adjustment
Contact Product Support Department.
Pump is air locked
Make sure vent hole in discharge pipe is clear.
Vertical lift too high
Change discharge piping or contact Product Support Department.
SK2844
DIMENSIONS
TROUBLE SHOOTING
If the above checklist does not solve the problem, consult the Zoeller Product Support Department at +1 (502) 778-2731.
Do not
attempt to service or otherwise disassemble pump.
Before servicing a pump, always shut off the main
power breaker and then unplug the pump - making sure you
are not standing in water and are wearing insulated protective
sole shoes. Under flooded conditions, contact your local electric
company or a qualified, licensed electrician for disconnecting electrical
service prior to pump removal.
Submersible pumps contain oil which become pressured
and hot under operating conditions.
Allow 2½ hours after disconnecting
before attempting service.
CAUTION
Do not dispose of feminine sanitary products, disposable
diapers, dish rags, etc. in the QWIK JON
®
ULTIMA . They may jam the
pump or other plumbing lines and cause malfunction.
CARE OF FINISH:
Soap and water is all that is recommended for cleaning
the outside of the tank. Other cleaning products may cause discoloration
and scratching.
[18 5/8”]
[20 1/8”]
[1 3/4”]
[14 1/2”]
[7”]
[12 3/4”]
[15 1/2”]
[9”]
[9 3/16”]
[2 7/8”]
[3 1/2”]
47.3cm
22.9cm
23.3cm
36.8cm
4.4cm
51.1cm
7.3cm
17.8cm
39.4cm
32.4cm
8.9cm
