if local code allows it.)
PIPING
STEP 4
While
1)
the discharge pipe, position and mark the location of
the pump unit discharge
Cut and
DN40 (1-1/2") vent pipe as required to ensure that
the
pipe does not interfere with other components. Make the
connection to the pump unit with the provided street elbow.
A 2" x 1" 90° discharge
has been provided. However, it
may be easier to pipe straight up depending on the installation.
Temporarily set the toilet in place to check that there is no piping
interference. Remove the toilet and set it aside.
5)
4)
3)
2)
Clean, prime and solvent weld the discharge piping and pump unit
discharge
When applying solvent weld to discharge
ensure that
none gets into the check valve assembly. Pay close attention to the proper
alignment of the discharge
previously marked.
6)
For markets requiring a pipe vent, clean and solvent weld the vent piping
as required for proper venting.
Proper venting is required.
Cut and
the pipe and
as required for
(1")
DN25
diameter discharge pipe (may be reduced to
[3/4"]
DN20
diameter
Note: Adding other bathroom
- The Qwik Jon
®
Choice is designed
to accept additional bathroom
utilizing the two side inlets.
Available for connecting DN25 (1") pipe. Simply reverse the pipe adaptor
dry-fit
fittings
fixtures
fixtures
and cut out the molded-in plug at the provided indentation.
dry-fitting
dry-fit
fitting.
fitting
vent
Cut cleanly and remove burrs and rough edges to avoid
the potential for clogging.
7)
Optional carbon filter vent:
For markets where a carbon filter vent is allowed, please replace the
carbon filter periodically to keep ventilation functioning properly.
Indentation
Available for connecting DN25 (1”) pipe.
Only need to reverse the pipe adapter.
Check Valve
Cross Section of side inlet
- 7 -
© Copyright 2022 Zoeller
®
Co. All rights reserved.
Check Valve,Pipe Adapter,and Adapter Fitting not
available on the 60HZ version.
The 60HZ version utilizes 2”NPT female adapters.