6
AQUANOT
®
SPIN
™
FLOAT SWITCH
FIGURE 3
SK3186
SPIN
™
CONTROLLER FUNCTIONS
There are two buttons on the front of the controller.
- Silence/Reset
• Can be pressed to silence current alarms for 24 hours.
•
Can be held for longer than 3 seconds to reset alarm. Reset will clear flashing light on unit.
- Test
• Will run the pump to determine if amp draw of pump is in range.
• Controller is factory programmed to self-test the pump for several seconds every 24 hours.
• Pressing the test button will start the 24-hour timer for self-testing.
Note: Holding both the silence/reset and test button at the same time for 5 seconds will cause a factory reset on the controller.
AQUANOT
®
SPIN
™
Solid
Flashing
Off
System Ready
No Faults (Green)
AC off with no faults (Green)
--
Battery
Charged (Green)
Low Battery (Red)
No AC Power
Charging (Yellow)
Bad Battery (Red)
DC pump
Pump Ran (Yellow)
Pump Running (Yellow)
--
Pump Fault (Red)
Float Status
*High Water (Red)
Sensor Activated
Float Fault (Red)
--
The LEDs will display information about the controller.
© Copyright 2019 Zoeller
®
Co. All rights reserved.
LOCKING PIN MUST BE
INSTALLED UNDER FLOAT
ROD IN THIS LOCATION.
MOLEX 4-PIN CONNECTOR
MOLEX 2-PIN CONNECTOR
FIG. 4
DC PUMP
DISCHARGE TEE
REDUCER FITTING
CLAMP
CHECK VALVE ASSEMBLY
CLAMP
SK2962
FIGURE 4
FLOAT STATUS LED
DC PUMP LED
BATTERY LED
SYSTEM READY LED
GROUNDED POWER CORD
SILENCE BUTTON
TEST BUTTON
WHITE LEAD
(POSITIVE)
BLACK LEAD
(NEGATIVE)
30 AMP FUSE
DC PUMP
HIGH WATER
OPERATIONAL
AQUANOT
®
SPIN
™
CONTROLLER
SK3187
* If optional high water reed sensor is being used.
