14
15
C
US
LR90197
UL Std. No. 778
ENCLOSURE 3
starwatersystems.com
Pump:
ES05S
Rev:
B
Motor:
98L105
HP:
1/2
PH
1
Hz
60
Volts
115/230
S.F.
1.2
Amps
6.4/3.2
S.F. Amps:
8.6/4.3
RPM
3450
Type
C
Duty:
Cont.
Temp
65C
KVA Code
G
Frame
56L
Ins Class
B
Factory prewired for 115V
Thermally protected automatic
Check voltage of power source
Use copper conductors only
ELECTRICAL HAZARD
Improper installation may result in fi re, explosion, electrical short or injury. Replace all covers
before operating. Ground motor in accordance with local and national electrical codes.
Disconnect power source before touching internal parts. Motors equipped with automatic
protection may restart without warning.
See instruction manual for proper installation procedure.
Se reporter au manuel d’instructions pour suivre la procédure adéquate d’installation.
Consulte el instructive para conocer el procedimiento de instalación correcto.
L1
L2
A
B
L1
L2
A
B
IL0180
YELLOW
115 VOLT
SINGLE PHASE
LINE
230 VOLT
SINGLE PHASE
LINE
WHITE
GRAY
RED
TAN
YELLOW
WHITE
GRAY
RED
TAN
DATE CODE:
0218*
Made in USA
1
To change from 115V to 230V
1. The motor of this pump is dual voltage and
can run on either 115V or 230V. In general,
230V is more economical to run, and
requires a smaller wire size.
NOTE: This pump is pre-wired at the factory to
run on 115 V.
A
B
L1
L2
IL1356
230V
GRAY
RED
2b
A
B
L1
L2
IL1355
GRAY
RED
2a
b.
Pull the red wire with the female flag
connector from the “L2” terminal. Place it
to the left on the “B” terminal spade post.
2a. For 230V service, change the following wires
on the terminal board:
a. Using a pair of needle nose pliers, pull the
gray wire with the female flag connector
from the “A” terminal spade post. Place
it to the right on the “B” terminal spade
post.
2c
c. Reinstall the rear motor cover.
NOTE: To change voltage from 230V to 115V,
simply reverse instructions above.
IL1351
2
IL1350
Priming Plug
with Pressure
Gauge
Air Relief Plug
1
CAUTION:
All pumps must be primed
(filling the cavity with water) before they are
first operated. This may take several gallons of
water, as the suction line will be filled in addition
to the pump cavity.
1. Remove the priming plug with pressure
gauge and air relief plug.
2. Slowly fill pump cavity until water comes out of
air relief hole on top of the pump.
PUMP PRIMING & STARTUP
IL1352
Water Level in
Pump Cavity
3
3. Replace air relief plug and continue adding
water to pump cavity until water reaches the
top of the priming plug.
IL1352
Water Level in
Pump Cavity
4
4. Check to be sure water in pump cavity stays
constant. If water level goes down, it could
indicate a leak in the foot valve, check valve or
suction pipe.
