Zodiac WAVE 275 Roll Up, Руководство пользователя, Страница: 9 / 18

9 / 12
E
N
G
L
I
S
H
INFLATION OF HP MODELS
Activate all valves into inflation position .
Fit the hose to the foot-pump.
To inflate your boat properly, the bottom side of the
foot-pump must rest on a flat ground
.
Pump evenly
to inflate rapidly.
CAUTION
DO NOT USE A COMPRESSOR OR A BOTTLE OF COMPRESSED AIR
A - INFLATE THE HP FLOORBOARD
1. Activate the standard valve into inflating position .
2. Inflate in position A (cap inserted ) until it becomes difficult to operate.
3. Finish inflation in position B (cap removed ) until you reach correct pressure (800 mb–11.3 PSI)
B - INFLATE THE MAIN BUOYANCY TUBE
CAUTION
MAXIMUM PRESSURE IN THE MAIN BUOYANCY TUBE:
240 MBARS (3.4 PSI)
NEVER USE POSITION B TO INFLATE THE MAIN TUBE OR THE KEEL :
THERE WOULD BE A RISK OF BURST.
1. Insert the pump hose end piece (add to the semi-recessed valve the correct connecting tip).
2. Inflate the main buoyancy tube and the keel ( in position A - cap inserted ) until it becomes
difficult to operate.(correct pressure = 240 mb / 3.48 PSI), reefer to PRESSURE section making
sure that each compartment is equal. When correctly inflated, the compartments bulkheads are
not visible.
NEVER INFLATE A
COMPARTMENT TO FULL
PRESSURE IF OTHER
COMPARTMENTS ARE
TOTALLY DEFLATED
a
100 %
0 % 0 %
1
50 %
50 % 50 %
2
100 %
100 %
100 %
INFLATE THE KEEL
•
Once the H2P floorboard is installed, inflate the keel (
240 mb – 3.4 PSI
).
Inflation is over: fit the valve caps tight (clockwise).
NOTICE :
A slight air-leak before screwing the valve caps is normal.
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS .