Zodiac PF Premium 11M TSR, Инструкция по установке и эксплуатации

Страница: 13 / 22

H03620
‐
00.D2.EN – 2013/03
12
5.2 Solving device malfunctions
Dysfunction Causes Verification / solution
The device is not
operational
No display Check the supply voltage and the fuse F1
The pool temperature is above the
set
‐
point temperature
Increase the set
‐
point temperature
A message is displayed on the screen Check the meaning of message §5.1
Absent or inadequate water flow
‐
rate Check the water flow
‐
rate (by
‐
pass, filtration)
The device is
operational, but water
temperature fails to
rise
Inadequate filtering time
Set the filtering system to manual 24
‐
hour
operation for temperature control
Non
‐
compliant period of use
Check that outdoor temperature is within the
operating range (see §1.3)
The heat pump is under
‐
dimensioned
Check the characteristics of the heat pump
according to the pool
The automatic pool water filler is
blocked in the open position
Check the correct operation of the automatic
filler
The heat insulating cover is not used Fit the heat insulating cover
The evaporator is clogged Clean the evaporator (see §4.1)
The device is incorrectly installed
The device must be installed outdoors.
Check that there is no obstacle less than 4
metres from where the blower is facing, and
0.50 metres behind the heat pump.
A message is displayed on the screen Check the meaning of message §5.1
The fan is turning, but
the compressor stops
from time to time
without an error
message appearing
The heat pump does defrost cycles
from time to time
This is normal if the outdoor temperature is
below 10 °C
The evaporator is clogged Clean the evaporator (see §4.1)
the heat pump makes
trip the circuit breaker
The circuit breaker rating is too low or
inappropriate
Check the circuit breaker (see § 2.5.3).
The cable cross
‐
section is too small Check the cable cross
‐
section (see § 2.5.3)
The supply voltage is too low Call your electricity provider
Voltage drops when the compressor
is powered on
Add a soft starter for models 11M, 11MTSR
and 13M
Varistor(s) VA1 and/or VA2 is/are out
of order
Replace the varistor(s)
5.3 FAQ
Is it possible to
improve
temperature
performance?
In order to
improve the
efficiency of
your heat
pump it is
recommended
that you:
protect the pool with a cover (floating cover, roller cover, etc.), to avoid heat
loss
choose periods when the outside temperature is warm (on average > 10° C)
in order to facilitate the temperature increase (this may take several days.
The actual time will vary according to weather conditions and the power of
the heat pump)
the higher the ambient air temperature, the more efficient the heat pump
will be
keep the evaporator clean
Check that
filtration time
is sufficient
during the heating phase, water flow must be continuous (24/24)
to maintain the temperature throughout the season, allow for “automatic”
flow of at least 12 hours/day (the longer automatic flow is used, the more
time the heat pump will have to function and to heat the water)
Setting the set
‐
point to maximum will not heat the water any faster