Zodiac PF Premium 11M TSR, Инструкция по установке и эксплуатации

Страница: 12 / 22

H03620
‐
00.D2.EN – 2013/03
11
Display Designation Cause Solution Reset
Refrigerant
circuit low
pressure defect
Low pressure circuit
pressure defect (if
the defect remains
after reset)
Contact an approved
technician
Automatic reset
(for less than 4
defects per hour)
or press
Refrigerant
circuit high
pressure defect
1. water and air
mixture passing in
the appliance,
2. unsatisfactory
water flow,
3. blocked flow
controller
4. clogged or blocked
heat exchanger
1. check the pool hydraulic
circuit
2. increase the flow
‐
rate
using the by
‐
pass, check that
the pool filter is not clogged)
3. check the flow
‐
rate
controller
4. clean the exchanger
5. if the defect persists,
contact an approved
technician
Automatic reset
(for less than 4
defects per hour)
or press
Compressor
discharge
temperature
defect
Compressor
discharge
temperature too
high
contact an approved
technician
press for 3
seconds
Control sensor
defect (ST1)
Sensor out
‐
of
‐
order
or disconnected
(connector J2 red on
plate A1)
Replace or reconnect the
sensor
Switch the power
supply off or
press
Water flow
‐
rate
sensor defect
(ST4)
Sensor out
‐
of
‐
order
or disconnected
(connector J8 white
on plate A1)
Replace or reconnect the
sensor
Switch the power
supply off or
automatic reset if
the defect
disappears
Defrost sensor
defect (ST3)
Sensor out
‐
of
‐
order
or disconnected
(terminals 1
‐
2 of
connector J3 white
on plate A2)
Replace or reconnect the
sensor
Switch the power
supply off or
press
Anti
‐
freeze
sensor defect
(ST2)
Sensor out
‐
of
‐
order
or disconnected
(terminals
3
‐
4 of connector J3
white on plate A2)
Replace or reconnect the
sensor
Switch the power
supply off or
press
Compressor
discharge
sensor defect
(ST5)
Sensor out
‐
of
‐
order
or disconnected
(connector J7 black
on plate A1)
Replace or reconnect the
sensor
Switch the power
supply off or
automatic reset if
the defect
disappears.
Communication
s' defect
between the
main card A1
and the display
card A2
1. Incorrect
connection between
plates A1 and A2
2. Card supply defect
3. Cards out of order
1 and 2. Check connections
(connectors J8 and J9 yellow,
and J7 and J4
‐
J5 black)
1, 2 and 3. if the defect
persists, contact an
approved technician
Switch the power
supply off or
automatic reset if
the defect
disappears