4
During the first 5 minutes of operation: the 3 coloured bars blink
,
One bar indicates whether the water flow-rate is:
too low
(red bar), close valve 1 a little, then, open valve 3 a little (or 5 if is present),
correct
(green bar),
too high
(red bar), close valve 3 a little (or 5 if is present), then, open valve 1 a little.
3. Overwintering and restarting
It consists of draining the water contained in the heat pump.
Approach you installer, who will indicate to you how to carry out the overwintering and la remise en
service.
4. Maintenance
Cleaning the evaporator:
Approach you installer, who will indicate to you how to carry out this maintenance.
Maintenance of the electrical components:
Approach you installer.
Maintenance of the draining of condensation:
Approach you installer.
Maintenance due to the presence of refrigerant gas:
Approach a certified refrigerator specialist to have him check the refrigerant gas load of your appliance.
4.1 Available accessories
(from your installer)
PAC NET
Wintering
cover
For ongoing improvement, our products are subject to change without notice.
Version of 12/2009 B
Cleaning your appliance using a high pressure water jet is strictly forbidden.
A general servicing of the appliance is recommended when wintering and restarting, to
check the proper operation of your appliance, maintain its performance and to prevent
some breakdowns
Wintering is essential, on pain of annulling the warranty, because the wayer
contained in the heat pump is liable to freeze and burst some components open.
During this adjustment phase, wait 30 seconds after each valve position change as
the regulator response time is not instantaneous.
In case of doubt on the identification of the valves, approach you installer.
EN
