3
2.2 Setting the desired temperature
Starting up
the heat pump is in stand-by:
,
press 3 seconds on
,
appears for 5 seconds,
then the water temperature is displayed.
Stopping of the appliance
press 3 seconds on
,
appears
Adjusting the temperature
press on
and
or
and
.
2.3 Regulator display
Display
Status / cause
Solution
heat pump stopped, waiting
wait for the filter to start up again, if the
message persists, contact your installer
Outside temperature too low
Wait for the outside temperature to increase
naturally
2.4 Adjusting the water flow
Putting the setpoint on maximum will not heat the water any faster.
: controller “on” indicator
: priority heating output enabled
indicator
: compressor “on” (steady) or
timed (blinking) indicator
: defrost in progress (steady) or
timed (blinking) indicator
: “on/off” or stand-by
: display required water temperature or setting
: setting values
V1-V2-V3:
by-pass valves
V5-V4:
Setting valve
(optional)