22
!
!
IMPORTANT!! The use of any products other than stabilised slow
dissolving chlorine tablets of the «Trichloro» type (such as unstabilised
chlorine tablets, granulated chlorine, liquid chlorine...) with the
Nature
2
Fusion chlorinator is strictly prohibited.
Make sure to slowly add the Tri-Chlor tablets to the feeder to avoid
splashing of chlorinated water.
The manufacturer will not be liable when this warning has not been
respected.
Using chlorine tablets
The chlorine diffuser (or «chlorinator») is used to keep a reserve of slow
dissolving chlorine tablets. The pool water fl ows through the cylinder and
takes in chlorine before returning to the pool. It can store up to 10 x 250 g slow
chlorine tablets.
The need for disinfectant in the pool varies depending, amongst other things, on
the number of bathers and the climate. For these cases there is an
adjustment
ring
that can be used to adjust the pool chlorine levels. It is located on the top
of the diffuser body, above the chlorinator. It has 6 settings in order to correctly
adjust the required amount of chlorine. At fi rst you will need to fi nd the optimum
setting in order to adjust the free chlorine levels correctly (0.5 to 1.0 ppm after
carrying out the start-up procedure).
WARNING!!: When fi lling the chlorinator the following precautions
should be taken:
➤
1. Nature
2
Fusion was design to exclusively use stabilised slow
dissolving chlorine tablets.
These are of the «
Trichloro-S-Triazinetrione
»
type (or
trichloroisocyanuric acid
also called «
Trichloro
» or «
ATCC
»). Never
mix these chlorine tablets with other types of chlorine or other chemicals;
this may cause fi re or an explosion.
➤
2.
Never mix several types of product in the appliance (algaecides,
shock chlorination treatments, multi-action products, granulated or liquid
products…): contact between these products and the slow chlorine tablets
may cause a dangerous chemical reaction.
➤
3.
Stop the fi lter pump and close all the appliance safety valves before
opening the chlorinator.
➤
4.
When adding chlorine tablets to the chlorinator it is recommended
not to inhale the chlorine vapours coming from the appliance. The room in
which the appliance is installed must be ventilated.
Always wear appropriate
safety equipment
(safety glasses, mask, gloves, and overalls).
➤
5.
Do not use petroleum based products to clean the joints; use clear
water.
➤
6. Make sure to open all closed valves before restarting pump. Failure to
open all valves could result in a build up of gas which can result in a FIRE or
EXPLOSION.
6
23
Procedure for adding chlorine tablets:
1.
Stop the fi ltering pump.
2.
Close all the safety valves that may be located between the fi lter and the
pool.
3.
Unscrew the black ring maintaining the adjustment ring.
4.
Gently remove the «adjustment ring + black ring» assembly by lifting using
the grey handle on the adjustment ring. Warning, this assembly has 3 moving
parts; do not try to separate them.
5.
Remove the black cylinder by lifting it. Once the cylinder has been removed
it is easy to fi ll it with chlorine tablets and/or clean it. Be careful of the water
tightness seal (it must remain in place when reassembling).
6.
Proceed in the reverse order to reassemble the different parts of the
chlorinator. When refi tting the «adjustment ring + black ring», turn the assembly
until it falls into the specially designed notches. Then tighten the black ring
manually.
Remark:
The 6 fi gures on the adjustment ring (from 0 = closed to 5 = maximum)
do not indicate the pool chlorine level but only give an indication of the amount
of chlorine used.
6 setting adjustment ring
Adjustment ring + black ring
Chlorinator cylinder
Diffuser body
