6
❷ Installation
2.1 I Setup
Hose length necessary
: Cleaner
: Hose sections
: Pool valves
: Suction line
: Skimmer
: Filtering pump
: Filter
Suction line connection example
2.2 I Hose section assembly
2.2.1 Determine the number of sections you need
•
Measure the length between the suction line or the skimmer and the furthest away point of the pool.
•
Add an extra 1 metre to the length measured.
•
If total length is over 10 metres (MX
TM
6 - MX
TM
630) or 12 metres (MX
TM
8 - MX
TM
8 PRO - MX
TM
9 - MX
TM
930 - MX
TM
10),
contact your reseller to purchase any additional hose sections required for your pool.
: Connection to the suction line or
the skimmer
: Hose length necessary
: 1 metre section of hose with
float
: Connection to the cleaner
Tip: assemble the "right" quantity of hose sections
Assembling more hose sections than the length necessary to cover the whole pool is not recommended.
Hoses that are too long may limit the cleaner's performance.
2.2.2 Twist Lock Hose section assembly
•
To easily assemble the two pipe sections using the Twist Lock system, connect them then twist until the connectors
are in complete abutment, in one of the 3 notches providing the seal (see image )
.
•
The section of Twist Lock hose with the hose float attached will be connected to the cleaner (see image ). The Twist
Lock hose float must be located
20-23 cm away from the cleaner
(see image ).
20-23 cm
Float
