•
Maintaining constantly high levels of salt and chlorine above recommended range can
contribute to corrosion of the pool equipment. Salt levels exceeding the recommended
concentration can be reduced by diluting the pool water with fresh water.
•
Do not add pool chemicals directly to the skimmer. This may damage the cell.
•
You should always test the chlorine levels of your pool before each use.
G. Spring
Start-Up
The output of the cell is determined by water temperature, salt level and mains voltage. In the
springtime when the water temperature of the pool may be below 18ºC (65°F) the ‘check salt’
light may light up. The ‘check salt’ light is only reliable at temperatures above 18°C (65°F)
because the temperature affects the conductivity of the water. There is no need to add salt if the
level is already between 3200 and 4000 ppm. In cold water there is very low chlorine demand
because of low bather load, therefore the chlorine output should be set to minimum or you may
not need the salt system on at all.
H. Backwashing pool filter
When backwashing your pool filter, turn off the Zodiac EZ SALT Chlorine Generating Device by
turning the control knob to zero. Remember to reset the chlorine output after back washing.
21
