9 / 12
E
N
G
L
I
S
H
INFLATING A CADET AERO BOAT
Activate all valves in the inflation position.
Attach the hose connector to the inflator inflation
port.
To inflate your boat properly, the inflator should be
correctly placed on the ground.
The boat inflates rapidly if the inflator is used
smoothly and without haste.
CAUTION
DO NOT USE A COMPRESSOR OR COMPRESSED AIR CYLINDER.
A - INFLATE THE HIGH PRESSURE FLOORBOARD
(AEROTECH MODELS ONLY)
1.
Inflate Insert the pipe as shown in figure A (with the cap inserted) and begin to inflate leaving
the cap inserted. The inflator uses its full capacity. Inflate until hard.
2.
Then remove the cap. The pump automatically uses the smallest chamber needed to provide
the High Pressure bottom inflation pressure without undue force. Complete inflation in position B until
the recommended pressure is reached
(see "PRESSURE" section)
B - INFLATE THE MAIN BUOYANCY TUBE AND THEN THE KEEL
CAUTION
NEVER USE POSITION B
TO INFLATE THE BUOYANCY TUBE
OR THE KEEL:
BURSTING HAZARD.
Inflate the buoyancy tube Insert the pipe as shown in figure A (with the cap inserted) and begin to
inflate leaving the cap inserted. The inflator uses its full capacity and allows the recommended
pressure
(see "PRESSURE" section)
) to be achieved. Make sure that the pressures between
the compartments are equalized, until the partitions (a) can no longer be seen.
Never pressurise a
compartment when the
others are completely
deflated
a
1
2
Then inflate the keel
(see "PRESSURE" section)
Inflating is complete: screw on the inflating valve caps.
NOTE:
A slight air leak is normal before the valve cap is screwed on
ONLY THE VALVE CAPS CAN ENSURE FINAL AIR TIGHTNESS.
