P a g e
|
29
Salt light is
on
and the display says “Check Salt
or Low Temperature”.
NOTE
The Salt light will turn on
when the salt level drops well
below 3,000 ppm and it will
remain on until the salt level is
raised above 4,000 ppm.
* If an AquaLink
®
RS or PDA is installed,
when the salt level is low, the AquaLink RS
or PDA will display, “Salt 2900 PPM, Check
AquaPure
®
, (Low Salt)”.
Salt level is well below 3,000
ppm, depending on water
temperature.
Maintain a salinity level of
4,000 ppm - 4,500 ppm
(see Section 4.6 or contact
your local pool professional).
Cell life expired.
Replace the cell.
Problem
Possible Cause
Corrective Action
Display says “Check Salt or Low Temperature”
(Salt light is
off
).
A combination of low water
temperature (2°-18°C / [35°-
65°F) and lower salt levels
(3,500 - 4,000 ppm).
Check salt level in pool water. If level is
between 4,000 - 4,500 ppm, no action is
necessary. If salt levels are lower than
4,000 ppm, raise the salinity level to
4,000 - 4,500 ppm (see Section 4.6).
NOTE
Salt levels above 6,000 ppm
may cause corrosion damage.
Problem
Possible Cause
Corrective Action
“Output Fault” appears on the screen.
Power supply.
Turn the power off to the power pack
and consult your local pool care
professional.
Problem
Possible Cause
Corrective Action
Salt level too high.
Too much salt has been added to
pool.
Backwash or partially drain pool and
dilute with fresh water until salinity
returns to 4,000 ppm - 4,500 ppm.
Problem
Possible Cause
Corrective Action
Salt level too low.
Not enough salt added to pool.
Add salt to pool until salinity returns to
Содержание APURE35C
Страница 35: ......
