+5400Pa/-3600Pa
（
6 clamps with 3 rails
）
≥
150mm
Use a torque wrench for installation, and the compression for each clamps is not strong to avoid potential
damages to module frames. The recommended maximum compression for each clamp is 20MPa (2900PSI).
The module mounting structure must be made of durable, corrosion-resistant and UV-resistant material. All
mounting hardware (bolt/flat washer/split washer/nut) should be stainless steel M8 size.
The minimum recommended length for each clamp is 60mm.
The modules have been designed to resist a static load, and the resistance value can decrease if modules are
not mounted following the instruction above.
This manual is just for reference. Customer can select the corresponding installation manual based on the
purchased module.
