ZMC408SCAN Hardware Manual Version1.2
2
1.2
Installation And Programming
ZDEVELOP Development Environment
ZMC controller is programmed and debugged by ZDevelop software. ZDevelop, the software
is easy to program, compile and debug. Link ZDevelop and controller through serial, 485, USB or
Ethernet.
Application procedures can be programmed by VC, VB, VS, C ++ Builder, C # and other
software development. When debugs, Zevelop software can be connected with controller
simultaneously, but needs a dynamic library when the procedure is running: zmotion.dll.
1.3
Features
⚫
Motion control of up to 16 axes. (EtherCAT/encoder axis/virtual axis)
⚫
Encoder position measurement is supported and can be configured as hand wheel input mode.
The specialized MPG interface supports 5-24V handwheel input.
⚫
20 PNP general outputs, and 8 channels are high-speed outputs, which can be configured as
high-speed comparison, PWM, etc. 12 general outputs, the max output current can reach
300mA, which can drive some solenoid valves directly.
⚫
24 NPN general inputs, and 10 channels are high-speed input, 14 channels are low-speed
inputs. Also, high-speed input can be configured to latch signal.
