XPLC300 Motion Controller Hardware Manual V1.5
3.1.5.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please select any one interface among the three interfaces
ETHERNET, RS232 and RS485 to connect to ZDevelop.
(3)
State values of relative input ports
can be read directly through “IN” command, also,
it can be read through “ZDevelop/View/In”. Please refer to “ZBasic” for details.
3.2.
U Disk
XPLC300 series motion controller provides a USB communication interface, which
can insert the U disk device. It is used for ZAR program upgrading, controller data
importing and exporting, file 3 executing, etc. Its schematic diagram is shown in the figure
below:
Содержание XPLC300
Страница 1: ......
