ZMODO DVR-H9106UVD-SV, Руководство пользователя

Страница: 17 / 38

Figure 10-40: Email Setup Menu
detect motion. Options are ON and OFF.
10.2.3 – ALARM MANAGE
· OUTPUT sets the duration for the external alarm. Options are OFF and 10,
20, 40 or 60 seconds.
· BUZZER sets the duration of the audio buzzer when an alarm condition is
met. Options are OFF and 10, 20, 40 or 60 seconds.
·
DURATION sets the amount of time the camera will record after the alarm
has been triggered. Options are 30 seconds, 1, 2, and 5 minutes.
· PreRec can be OFF or 10 seconds. When set to 10 seconds, channels on
which motion is detected record 10 seconds prior to motion detection
activation.
10.2.4 – E-MAIL SETUP
This menu is used to configure the DVR to send an
e-mail message to a designated address when an
alarm condition is met.
To begin the e-mail configuration, select ON from
the EMAIL drop-down menu. Doing so will reveal
the configuration fields.
SSL
Secure Socket Layer, is a security protocol used by some e-mail providers to
protect communication over the Internet.
Some e-mail services require the use of SSL, such as Hotmail and Gmail. Check
with your e-mail provider.
If it used, enable the SSL feature by clicking the ON radio button.
SMTP PORT
SMTP, or Simple Mail Transfer Protocol, is used by many user-based e-mail
services for outgoing messages.
Enter the SMTP port that the e-mail service provider uses. In most cases, the
port is 25 or 465. Check with your e-mail provider.
SMTP
This field is for the SMTP server address used by your e-mail provider. Check
with your e-mail provider.
The format of the address would be similar to smtp.emailprovider.com.
SEND EMAIL
Enter an e-mail address to identify that the DVR is sending the alarm notification
10.2.1 – I/O CHANNEL AND STATUS
I/O (input/output) channels are to connect external sensor alarms to the camera
on the specified channel.
An example of an external sensor is a laser-activated motion detector.
External sensors are not necessary to detect motion. The DVR is equipped with
an internal motion detection system.
The first drop-down menu in the upper-left is to select the group of four channels
to configure.
The I/O Status drop-down menu has three options:
·
NO – Normally Open. The external sensor's
default state is an open (off) circuit.
·
NC – Normally Closed. The external sensor's
default state is a closed (on) circuit.
·
OFF – The external sensor channel is turned off.
The external sensor channel will not be used.
10.2.2 – NOTIFICATION OPTIONS
HDD Loss
When HDD LOSS is checked, the system alarm will be triggered, sounding the
buzzer (if enabled). Hard Drive loss occurs when the hard drive is taken offline,
either by drive failure or disconnection from the DVR.
Whether the alarm is set to On or Off, a red square with a white H will be displayed
on the main video screen if hard drive loss occurs. The H icon will also appear if
there is no hard drive installed or if it has not been formatted.
HDD SPACE
When this trigger is enabled, the notification will be activated when the remaining
space on the hard drive is too low to continue recording.
If the buzzer is set to off, no audio alarm will occur.
Video Loss
Video Loss occurs when the video input from the camera is interrupted from the
DVR, either by physical disconnection or camera failure.
“VIDEO LOSS” will be displayed on the main video screen for the affected
channel(s).
Video Loss is normal when powering on the DVR for the first time before
connecting cameras.
Motion Buzzer
Buzzer alarm is activated when motion is detected on one of the cameras set to
USER MANUAL USER MANUAL
28 27
Figure 10-40: Alarm Setup menu