1-Depending on the position of the linkage, determine the location of aileron control horn.
The horn holes must be perfectly aligned with the axis of articulation.
2-Mark the position of the “foot” of the horn on the aileron. Then, with the drill, make the 2
holes.
3-Install the aileron control horn as shown.
..........4
WING - BOTTOM VIEW
1-Cut away the covering of the wing bottom
where the aileron servo goes.
3-Install the aileron
and flap
servo on the servo mount.
-Switch on the radio (trims centered)
Then mount the ailerons servo horn
In neutral position.
-The servo horn should be
Perpendicular to the servo
YES
NO
Do the same way with second wing half
....2
2x
2
0mm....4
X
2 mm
Aileron pushrod
Adhesive
tape
2-Connect the aileron and flap servo cord to the
extension cords.
WING - BOTTOM VIEW
The rectangular hole on the bottom
of the flap is pre-cut at factory
Control horn Alignment
CA
Thin CA
2x30mm
3mm
....2
EZ link
...4
ZLIN
Z-526
1- Aileron and Flap servo
2- Aileron and Flap control horn
3- Aileron and Flap - Linkages
