Install the horizontal stabilizer onto the fuselage and adjust the alignment as described in steep 18B.
Note: it is important to ensure that the horizontal stabilizer is also level in regards to the fuselage.
Apply the thin CA along the area where the covering was removed in the previous step and to the
fuselage where the horizontal stabilizer mounts .
Trial fit the vertical fin in position. Using
a 90 degree triangle, ensure that the
vertical stabilizer is perpendicular to the
horizontal stabilizer.
Using a pencil, trace around the vertical
stabilizer where it meets the fuselage.
Remove the vertical stabilizer from the
fuselage.
Pull the rudder out of the vertical fin.
Carefully, push the vertical fin into the
slot on the fuselage as shown.
90 degree
triangle
20A
20B
CA
Apply CA glue
both sides.
(thin CA)
CA
Apply thin CA glue into the slot where
the fuselage meet the horizontal stabilizer.
ZLIN
Z-526
19- Horizontal stabilizer
20- Vertical stabilizer
B
B’
B=B’
