14
system exits when setting successfully.
Configure Tamper Alarm
If this function is enabled, alarms are generated once the device is
disassembled.
Configure whether to enable the disassembly alarm.
1. The administrator
password is authenticated.
2. Press7.
(The indicator turns green
and makes a long beep.)
3.Configure whether to
enable the t
amper
alarm.
(0: enable; 1: disable).
5. Exit.
(The device automatically
exits the process when the
operation is completed.)
4. The configuration is
successful.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
Note: The indicator turns red and makes a long beep in fourth step indicates
system exits when setting successfully.
Configure Alarm Delay for the Door Status Sensor
DSen. Delay (Door Sensor Delay)
: indicates the delay in checking the door
sensor after the door is open. If door sensor state is inconsistent with the
normal state set by the door sensor switch, an alarm will be generated, and this
period of time is regarded as the “door sensor delay”.
1. The administrator
password is authenticated.
2. Press
０
.
(The indicator turns green
and makes a long beep.)
３．
Press 4.
(The indicator turns green
and makes a long beep.)
5. The configuration is
successful.
(The indicator turns green
and makes a long beep,
then turns red and makes a
long beep again.)
４
.Configure the alarm
delay
(range: 1 to 254).
6.Exit.
(The device automatically
exits the process when the
operation is completed.)
Note: 1.Three-digit values are automatically verified. For values with less than
Поставщик систем безопасности: TELECAMERA.RU
