2
2 Installation Notes
In order to keep the arm won't be damaged during the transportation. The arm wasn't install on
device.
1.
Put arm kit into the hole of cabinet, make sure the screw holes match with mechanism core,
then tighten 3 hex screws, as shown in Figure 2-1.
Figure 2-1
2.
Please make sure that the power requirements are strictly met to avoid permanent damage to
the unit. Input voltage: AC 100~120V/200~240V.
Power on and wait 30s for the tripod turnstile to finish the self-check program.
3.
Lift the arm manually, as shown in Figure 2-2.
4.
Push arm
Lift upwards
Figure 2-2
Note:
If the arm can not be lift, please push the arm to close to cabinet direction first, then lift the
arm manually.
