LPRS2000 Hybrid Recognition Integrated Machine User Manual 5
2
Connection
2.1
Connection Setup
The camera is connected to a switch or a PC over the standard Ethernet port.
The reader is connected to the camera by Wiegand.
The camera and reader are connected to a DC 12V 1A power adapter.
If the camera is connected to a central power supply, the power input polarity and the power
interface must be connected correctly.
2.2
Network Settings
Network and IP Address Configuration Set the IP address of the camera to be in the same network
segment as the PC.
Note:
IP addresses in the same LAN cannot be the same; otherwise, IP address conflict will cause
device malfunction.
Default Parameter Settings Set the
IP address
,
gateway address
, and other information of the
camera properly before use. You can modify the default parameter settings according to requirements.
IP address: 192.168.1.88(Remarks: The device model is displayed on the label attached to the device
enclosure.)
Subnet Mask:
255.255.255.0
Gateway:
192.168.1.1 2.2.2
Connectivity Test After you set the camera IP address, click Start > Run in the lower left corner of the
