BG300 Barrier Gate
User Manual
P a g e
|
1 0
Copyright©2022 ZKTECO CO., LTD. All rights reserved.
5
Installation Procedure
Installation Precautions
1.
Install the parking barrier on a flat surface. A cement foundation is required before
installation if the ground is not solid and flat.
2.
It is possible to reduce the length of the boom, but it cannot be increased. After the boom
has been cut, it is important to set the spring balance again to achieve a new balance. The
bottom of the spring contains two plastic nuts designed to adjust the new balance.
3.
When the barrier is powered on, do not change the wire connection inside.
4.
Connect the GND to the cabinet to ensure protection.
Cable Embedding
1.
25 protective sleeve and a cable are required.
2.
The route cables must pass through the protective sleeves.
3.
Use a tool to open the cable tray on the ground.
Minimum 800mm
