Summary
* Please ensure correct
placement of fi nger on
reader.
* Ensure to disconnect all
power cables, before at-
tempting maintenance.
1. Getting started
1.1 Fingerprint Placement
Recommended fi ngers: The index fi nger, middle fi nger or the ring fi nger; the thumb and
little fi nger are not recommended (because they are usually clumsy on the fi ngerprint
collection screen).
Please enrol and verify your fi ngerprint by using the proper fi nger placement mode. We
shall not be held accountable for any consequences arising out of the degradation in
verifi cation performance due to improper user operations. We shall reserve the right of
fi nal interpretation and revision of this document.
1.2 Instruction for Card Swipe
This device is supplied with an integrated non-contact RFID (125 MHz) card reader mod-
ule. By offering multiple verifi cation modes such as fi ngerprint, RF card and fi nge
RF card verifi cation, this device can accommodate diversifi ed user needs.
Swipe your card across the sensor area after the voice prompt and remove your card
after the device has sensed it. For the swipe area, please see 2.2.3 Product Appear-
ance.
1.3 Precautions
Protect the device from exposure to direct sunlight or bright light, this greatly affects the
fi ngerprint collection and leads to fi ngerprint verifi cation failure.
It is recommended to use the device under a temperature of 0–50°C so as to achieve
the optimal performance. In the event of exposure of the device to the outdoors for
long periods of time, it is recommended to adopt sunshade and heat dissipation facili-
ties because excessively high or low temperature may slow down the device operation
and result in high false rejection rate (FRR).
When installing the device, please connect the power cable after connecting other
cables. If the device does not operate properly, be sure to shut down the power supply
before performing necessary inspections. Note that any live-line working may cause
damage to the device and the device damage arising out of live-line working falls be-
yond the scope of our normal warranty.
For matters that are not covered in this document, please refer to related materials
including the installation guide, access control software user manual.
3
