ZIVE LAB ZIVE SP2, Руководство по оборудованию

Страница: 10 / 46

ZIVE SP2 Instruction manual
- 10 -
Chapter 1. Pre startup checking points
1. Hardware
Note: From serial number R**********S , You must move interface board ROM write protection switch
direction to write enable direction inside of instrument for the following case

License code registration

Channel expansion setting

USB firmware upgrade
After the above modification, you must set ROM switch as write protect direction

Don’t place EMI producing equipment near this instrument (such as radio, vibration etc.).

The cell cable itself can work as antenna. (It can receive EMI noise). Never allow the cell cable to
cross or come in contact with any power line cable.

If the result data is noisy, it may be necessary to make the cell cable as short as possible. (As this
reduces induced noise.)

The counter electrode is dangerous. Do NOT touch this electrode.

Do not place any obstacle preventing air flow at bottom or the side of the unit

ZIVE SP2 should only be used with the supplied cell cable. If you use a custom made cell cable, it
is likely to create noisy data.
2. Calibration

Calibration of the ZIVE SP2 instrument is accomplished by using independent SM toolkit software..

Calibration will be done automatically.

During calibration the cell cable must be disconnected from the instrument

Never turn off the power during calibration...

During Calibration, Do not locate EMI noise sources(radio, frequency generator, vibrator etc.) near
the ZIVE SP2.
3. If you have trouble or questions;
If you have trouble on ZIVE SP2 or question, please send the following file and explanation to
service@wonatech.com.

Data file (SDO,SDE,SEO)