8) Plug the LED connector of the car top onto the car chassis circuit board male connector as shown.
Connect body top-antenna.eps
9) Thread the ANTENNA through the hold in the BODY TOP. Snap the BODY TOP to the back of the
CHASSIS, and then secure the front by gently pushing the BODY TOP onto the CHASSIS as shown.
5
Charging and Programming Channels
1) Set ON/OFF to ON to turn on the CONTROLLER. The indicator lights steady green.
2) Slide ON/OFF at the bottom of the micro RC to ON.
3) Open the cover on the top of the CONTROLLER. Align the metal contact points on the car’s chassis
with the metal contact points on top of the CONTROLLER. Place the micro RC in direction as shown
below and snap it into position – it will lock automatically. The indicator blinks in red to indicate
frequency channel programming in progress. It takes about 10 seconds for programming.
4) If programming is successful, the indicator lights steady red and Charging starts with 60 seconds
duration. If programming is failed, the indicator turns amber but battery charging still continues for 60
seconds. In this case, you must detach the car to clear the programming fail state. Be sure you turned
the micro RC on.
5) The indicator turns green after the micro RC has been well charged. Press RELEASE to unlock the
micro RC.
Charging car.eps
1
2