4) Rotate the MOTOR CLIP WITH SET SCREW as shown below to set the MOTOR in position.
Install motor2.eps,
5) Secure the MOTOR CLIP WITH SET SCREW with the SCREWDRIVER which is stored at the
bottom of the CONTROLLER.
6) Plug the TRANSFER GEAR into the axle as shown. Be sure the TRANSFER GEAR meshes with the
DRIVE GEAR on the STOCK MOTOR.
installs motor3.eps
Caution: Do not over tighten the SET SCREW until the MOTOR CLIP WITH SET SCREW becomes
slanted. It should be horizontal.
Caution.eps
7) Plug the HUBCAPS into the REAR AXLE GEAR, and then press the TIRES over the HUBCAPS.
Next, secure the REAR AXLE GEAR assembly into the CHASSIS as shown. Be sure the REAR AXLE
GEAR meshes with TRANSFER GEAR.
Mount rear axle wheel.eps