Drill holes for the cover base
Use the cover base as a drill
template
4
A
INSTALL THRU-HULL FITTINGS
ABOVE THE WATERLINE
1
Mark the center of
the thru-hull fitting
Drill holes (x4) for the cover base
Use the cover base as a drill template
Ø 4 mm (5/32")
3
4
7
8
5
6
1.
Pilot hole
2.
Hole saw
Ø 3 mm (1/8")
Ø 19 mm (3/4")
Drill holes for thru-hull fittings (1 or 2 holes)
1.
Pilot hole
2.
Hole saw
3.
Tap
Ø 3 mm (1/8")
Ø 16 mm (5/8")
M18 x 2.5
Option 2 (threaded hole):
Option 1:
Apply sealant (x4)
Cover base:
Metal hull:
Machine screws
(not included)
GRP hull (x4):
T25 (ST 4.8x25)
2
Ø 4 mm (5/32")
Place the cable cover
on top of the interceptor
and and cut it alongside
the thru-hull cover base.
If neccessary use the
cable cover extension kit
(CC-EX, optional) and
cut it to desired length
Waterline
Dual-
servo
Single-
servo
Snapp off
the thru-hull
center piece(s)
INTERCEPTOR
INTERCEPTOR
Remove excess sealant
with a knife or a spatula
B. MOUNT THE BACK PLATE
1
3 INSTALL THE BACK PLATES
B. MOUNT THE BACK PLATE
Apply sealant
GRP hull:
T40 (ST 8.0x45)
Metal hull:
Machine screws
(not included)
Apply sealant
1
2
4
3
NOTE!
Remove Servo unit(s):
(x3)
T25 (PT 5.0x18)
400 E:
600 E:
800 E:
1000 E:
x6
x9
x13
x17
400 E:
600 E:
800 E:
1000 E:
x6
x9
x13
x17
A. FOR THRU-HULL FITTINGS ABOVE THE WATERLINE
GO STRAIGHT TO STEP B.
Slide out the cable
plug to remove
the servo cable(s)
2
Remove the
back plug(s)