932213 Rev. C
24
E N G L I S H
I X .
6. Mode Button (J) and Mode Switch (option)
The mode button and mode switch allow you to select from 4 (four) different programmable
drive profiles or actuator mode sets.
• Push up the on/off mode select toggle switch to index among the four drive and actua-
tor modes. The selected mode indicator will flash.
• Push joystick either left, right, forward or reverse to select one of the four drive pro-
files. To select the actuator modes, push up on the mode select switch twice.
• The drive profiles are indicated by the mode indicators (G) and the actuators are indi-
cated by the four actuator lights (H).
• To exit drive mode, simply push the joystick to begin driving.
• To exit actuator mode, simply push the on/off mode toggle up one or more times until
the indicator no longer flashes.
7. Joystick (E)
The joystick controls the direction and speed of your chair. Turn the chair on and move the
joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disengages the brakes, allowing
the chair to move.
• The chair will move faster the more you move the joystick away from neutral.
Q-NOTE–
If your speed becomes hard to manage, release the Joystick and the chair will come to a
complete stop.
• When you release the joystick it will return to neutral; the chair will slow to a stop and
the brakes will reengage.
• We recommend that you switch the chair off if you stop for any length of time. This
will conserve battery power.
Q-NOTE–
Once the chair stops, switching the chair off will not affect the brakes.
9. Joystick Boot (F)
Make sure the boot is not torn or cracked (this could allow debris, water or moisture to
enter). If the boot is torn or cracked, replace it as soon as you can.
10. Remote Switch Jacks (option– not shown)
Two 1/8" switch jacks are optional to provide remote switch control of the on/off power
function and the mode select function. Any of the single switches offered by Sunrise Medical
can be used to connect to either or both of these jacks (except the single zero touch switch).
WARNING
1. Never use the ON/OFF switch to stop your chair except in an emergency.
This will result in an abrupt stop, and may cause you to fall.
2. To slow or stop your chair, return the joystick to neutral.
H. ENHANCED DISPLAY
Please refer to the Quickie Enhanced Display owner’s manual.
I.
MOTOR LOCKS
Disconnect the motor locks when you need to manually push
the chair. (For example, in an emergency, or if batteries fail).
WARNING
1. Do not disengage motor locks unless power to the chair is off.
2. Be aware that the chair will not have brakes in the free-wheel position.
3. Make sure that the person pushing the chair has full control when motor locks
are disengaged.
1. To Disengage Motor Locks:
Pull the lever out and away from the wheel to disengage the motor lock.
2. To Engage Motor Locks:
Push the lever in to return to the drive position.
Q-NOTE–
If the lever is difficult to disengage, rock the wheelchair slightly from front to rear and/or
push against the chair while moving the lever.
B
A
G
H
J
E
F
QR3 Remote Joystick
Enhanced Display
