OPERATION
35
ZI-MD300
•
Push the oil infill bolt back into the opening
as far as possible, but do not screw it in.
(Make sure that the dipstick is really pushed
in completely - occasionally it gets
jammed).
•
Pull out the oil infill bolt again and check
the oil level. There are two markings for this
- see illustration on the left.
•
If the oil level is low, fill up the recommend-
ed oil (see technical data) to the upper rim
at the maximum (maximum filling volume:
see technical data - do not overfill!)
•
Insert the oil infill bolt again and retighten
it.
•
Wipe away oil residues.
13.3.2
Refuel
WARN IN G
Use only unleaded fuel with min. 95 octane (corresponding device fuel)
Never use 2-stroke mixture of diesel! DAMAGE OF ENGINE!
N OTICE
Follow the safety instructions for fuel control.
Filter the fuel before refuelling to prevent for-
eign particles from entering the combustion chamber. Wipe up spilled fuel.
•
Refuelling only outdoors!
•
Before removing the fuel tank cap, turn the
motor off and let the machine cool down.
•
Clean the fuel tank cap area.
•
Remove the fuel tank cap carefully.
•
Visual check of the filling level.
•
If necessary, refill with fuel.
•
Fuel tank capacity: see technical data. Fill
tank only up to 1.5 cm below the rim of the
filler neck, so that the fuel has place for ex-
pansion.
NOTICE:
use fuel with the appropriate octane
number (RON 95).
•
Replace and tighten the fuel tank cap.
•
Wipe any fuel residues and wait until it
evaporates.
13.4
Operation
13.4.1
Start the engine
Start the engine, if you have your machine mounted according to the instructions and it is filled with the
necessary fuel and oil:
