OPERATION
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
27
ZI-HEK40V-AKKU
N O T I C E
Two-hand safety circuit:
The hedge trimmer is switched on and operated with both hands. One hand
operates the switch on the rear handle, the second hand the safety switch on the handlebar. If you release
one of the two
switches, the cutter bar automatically stops.
Switching on:
Hold the hedge trimmer firmly with both hands.
Press and hold down the switch interlock (1.).
Press the switch (2.) and the safety switch (3.).
The hedge trimmer runs.
Switching off:
Release one of the two switches.
The cutter bar stops immediately.
Battery state of charge:
Press the button on the battery to check the state of
charge at the state of charge indicator LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must be
recharged. If none of the LEDs light up after the button
is pressed, the battery is faulty and must be replaced.
W O R K I N S T R U C T I O N S
Check that all parts are firmly attached and obviously undamaged.
Look over the working area and remove any obstructions.
Remove all foreign objects from the hedge, such as wire or other parts, as these may block or
damage the cutting mechanism.
Cut out thick branches beforehand using pruning shears.
Pick up the power tool in both hands as specified.
Always cut at full engine speed.
Start cutting only with the cutting mechanism running.
The impact guard protects you against unpleasant impacts, e.g. recoil torque of the cutter,
when striking a solid object (wall, ground, etc.).
Never touch wire fences or the ground with the running cutting mechanism.
If cutting hedges over a prolonged period, interrupt your work more frequently and oil the
cutter bar.
Switch the engine off and remove the battery:
–
to remove blockages (jammed clippings) from the cutting bar;
–
if the machine behaviour changes or it vibrates unusually;
–
if you have come into contact with foreign objects or the ground
–
when taking breaks and leaving the machine unattended.
After use, stop the motor and wait until all rotating parts have come to a standstill.
Place the protection hood on the cutter bar.
Autogoods “130”
130.com.ua
