23
Rear Hub Bearing Installation
Install the wave spring onto the non-drive side of the axle. You may
need a tool to press the wave spring against the bearing face.
NOTICE
Do not scratch the axle when using a tool to install the wave spring.
Apply grease to the following locations on the drive side and non-drive
side axle ends:
• Axle front surface (a)
• Axle radial surface (b)
• Bearing front face across bearing seal, inner- and outer ring (c)
NOTICE
If a brush is used to apply grease, confirm there are no loose bristles
in the grease or on the part.
Press the end caps onto the axle.
Clean the hub with isopropyl alcohol and a shop towel.
12
Klüber Staburags NBU30 grease
a
c
b
13
a
c
b
14
15
Isopropyl alcohol
Shop towel
