P R O V E E
36
Set the radio box between the ply rails, about
1 inch behind bulkhead 4.
Sand the insides of the rails where the radio box
goes.
Set the radio box in place, ½ inch behind bulkhead
4.
Make sure the box is in correctly (rudder servo in
rear).
If all is well, attach the radio box.
We use silicone or hot glue on the sides only.
Put a little blob of glue on each corner. Only glue
the sides, not the bottom.
If you ever need to remove the radio box, you can
simply run knife blade through each glue blob.
