P R O V E E
13
Repeat for the bottom chines. Glue to both CS as
well.
You can make great clamps from some 3 inch PVC
pipe.
We sliced it into 1 inch pieces with the band saw,
and cut out a small section of the circle.
These clamps are cheap, and work very well.
Add a little extra glue at the nose. We need some
strength here.
Glue the rear of the deck chines into bulkhead 5.
You will have to twist the chine so that it is flush
with bulkhead 5 (flat). We used medium CA with
accelerator, and held them for a minute until cured.
Glue to CS at the same time with Titebond III.
Double check that all chines are flush with their
respective bulkheads and the CS are in the proper
position. Allow to cure.
Note that the CS may or may not exactly follow the
curve of the chines. They really don’t need to. They
are there to provide vertical support for the bottom
sheet.
