I L L U S I O N
11
Side chine flush with the bottom of the sponson
side.
Side chine centered at tip.
Bottom chine in place.
Be sure that the side chine is not hanging down
below bulkhead 6 also.
Use thin CA and accelerator to glue the side chine
in place.
Repeat on the other side.
Bottom Chines
Remove the bottom chines from the sheets and
sand lightly.
Press the bottom chine into the slits in the
bulkheads.
Fit the tab into the slot at the nose of the side chine.
The fit should be tight. You may have to tap this
part in place. Be careful, as the chine is somewhat
fragile until it is glued in place.
When the bottom chine is fully seated in all slots,
glue with thin CA and accelerator.
Repeat on the other side.
Reglue the chines with thin CA.
