ES3, ES4 & ES6 Instructions. Issue: No. 2
Page 12
February / 2012
Commissioning
1. Close the circuit breaker to connect the electrical supply.
2. Check everything is working as it should and the water temperature is achieving
the desired temperature. If not follow the guide below to correct the
temperature.
Temperature & flow adjustment
(Authorised Technicians Only)
The maximum outlet temperature can be set between 30°C and 50°C.
The factory setting is 38°C.
Water too hot
•
Decrease the temperature by turning the potentiometer (Fig. 7) clockwise until
the desired temperature is achieved.
Water too cold
•
Increase the temperature by turning the potentiometer counter clockwise until
the desired temperature is achieved.
•
If the desired temperature cannot be achieved the red LED on the PCB will light
(solid) to show that the unit cannot achieve the preset temperature. (See LED
functions on page 14).
•
In this case it will be necessary to adjust the water flow through the unit.
•
The flow rate can be adjusted with the adjustment screw (Fig. 8)
•
Turning this screw clockwise reduces the flow rate; turning it counter-clockwise
increases the flow rate.
•
Turn the adjustment screw clockwise; reducing the flow rate until the desired
temperature is achieved.
Fig. 7
Fig. 8
CAUTIOn!
Do not turn the adjustment screw further than the indent mark in
order to avoid water leakage.
Содержание InLine ES3
Страница 2: ...Inside Back Cover Inside Front Cover...
