805846US v1.04 06.21 HydroTap G4 User Guide
Page 15 of 32
OPEN
Position
CLOSED
Position
ON
OFF
After replacing the filter and flushing, the counters must be reset.
At commissioning, the Zip HydroTap starts a self-calibration
program. Once complete, the system proceeds to normal
operation. If you experience excess steam from the tap, please
recalibrate the system following the below steps.
1. Press [MENU] -[Install]
-[Boiling Calibration].
2. In the next screen,
press [Calibrate] to start
calibration. Calibration will
take about 10 minutes.
3 - Boiling Calibration
2 - Filter Reset
NOTE:
Occasionally the system will vent steam from the faucet.
This is normal operation as HydroTaps are programmed to re-
calibrate at regular intervals.
1. Press [MENU] - [Install] - [Filter
Reset].
2. Press [Reset Internal Filter].
The date and usage at the time
of reset will be recorded in the
Filter Log.
3. To set the filter life or edit
filter usage, refer to section
G- Filter.
Section C
