S
u
b
je
ct
t
o
t
e
ch
n
ic
a
l
a
lte
ra
tio
n
s
a
n
d
p
ri
n
ti
n
g
e
rr
o
rs
•
F
ir
st
e
d
it
io
n
0
3
/2
0
0
8
;
R
e
vi
se
d
0
7
/2
0
2
3
ZinCo GmbH
Lise-Meitner-Strasse 2 ∙ 72622 Nürtingen ∙ Germany
Phone +49 7022 6003-0
[email protected] ∙ www.zinco-greenroof.com
Installation Instructions
Fallnet
®
SB 200-Rail
2.2 Measuring and Positioning the Solar Base SB 200/Rail Supports
The positioning of the SB 200 Solar Base plates with the rail supports
(maximum distance between rail supports is 1.5 m) is to be measured
using a map of the roof. The Solar Base SB 200 must lie flat, straight
and on a clean and suitable (see 1.2).
The multiple perforation of the SB Rail holders makes it possible to place
them in such a way that the rail line later runs with sufficient distance to
the PV modules or to the railing and the distance of the rail to the edge
of the fall specified in the planning is maintained.
We recommend that you let the ZinCo technical department plan or
check the requirement and location plans.
2.3 Assembly of the rail
Je nach Einplanung besteht eine Anschlagschiene aus:
- rail 6 m
- rail 3 m
- rail 2 m
- joint connector
- end piece
- 90°-corner piece
- 3-way junction incl. support
- runner
- rail special length
- Every rail support is equipped with a square-head bolt. Using this
square-head bolt the rail is
threaded with the T-slot and thus connected
to the already positioned grid unit.
Required tools:
- wrench/ratchet 17.0
- allen or allen key size 6.0
- torque wrench
- optionally ZinCo Drilling Set to manufacture rail pieces of special
lenghts on-site
≤ 5 mm
-
The
rail track is extended by attaching further pieces of rail by means
of butt joint connectors. The self-locking nuts are to be tightened
manually (max. 20 Nm). A maximum gap of 5 mm between the rail
pieces is to be observed.
- Before completing the rail track, insert the mobile attachment point
(runner) onto the rail.
- Any required fitting pieces can be manufactured directly at the
construction site using the ZinCo Drilling Set (see separate instructions).
- Depending on the site planning, a closed loop-shaped system or a
termination with ending pieces is possible.
- Finishing with rail end pieces:
Screw end pieces onto the ends of the rail using butt joint connectors.
The end pieces are threaded over the rail support of the grid unit AE
and fastened between the first or last butt joint connector and the
stop screw of the end piece (available room approx. 120 mm).
A longer rail overhang is not permitted!
- Finally, check all screw connections and tighten them.
120 mm
Assembly end piece
Assembly joint connector
variant 1:
variant 2:
Assembly rail and support
Page 2 of 9