ZIMO MX31FU, Инструкция по эксплуатации

Страница: 22 / 29

Page 22 MX31 Cab, MX31FU Radio Cab
15. MENU and
MENU FUNCTIONS
OPERATOR, EXPERT
The menu leads to different functions, mostly for adjustments and definition procedures at the pre-
sent level, system level or device level.
WHEN?
▼
from the LOCO mode (green display) with the M key to the RUN menu,
▼
from the SWI mode (red display) with the M key to the SWI menu.
Entering the menu structure is not possible while the cab displays the recall memory, list of names
or while running an E-Procedure, even though the screen is also green or red in these cases.
▼
Multiple M key actuation (2 or 3 times) jumps directly to the SYSTEM or the CAB menu.
CAB?
■
Display is yellow with menu selections in table format.
HOW? (in table format)
♦
Use the scroll wheel or the F / W key’s (up / down) to make a selection and the A key to accept the
selection (marked with “>”).
♦
The E key escapes from a lower menu level to the next higher level (i.e. from the CAB to the SYS-
TEM menu or the SYSTEM to the LOCO or SWI menu).
WHERE TO AND BACK?
►
The E key escapes from a lower menu level to the next higher level (i.e. from the CAB to the
SYSTEM menu or the SYSTEM to the LOCO or SWI menu) and exits the menu altogether after
reaching the highest level (LOCO or SWI).
From the LOCO mode
with the M key
to the menu!
(likewise from the SWI mode)
LOCO mode LOCO MENU
THE MENU STRUCUTRE:
After entering the menu with the M key, the appropriate LOCO MENU or the SWI MENU appears
with all applicable selections. The first line accesses the SYSTEM MENU while the first line in the
system menu is for entering the CAB MENU.
MENU from SW-Version 1.10; with future extensions !
A A
key key
LOCO MENU SYSTEM MENU CAB MENU
(selected from the LOCO MENU) (selected from the SYSTEM MENU)
A A
key key
SWI MENU SYSTEM MENU CAB MENU
(selected from the SWI MENU) (selected from the SYSTEM MENU)
LOCO MENU .
> SYSTEM MENÜ
OPERATOR mode The currently active mode is marked with a check mark.To change to a
EXPERT mode different mode, scroll up or down, press the “A” key to mark the new mode
GUEST mode and exit with the “E” key.
x DEF West-East display Definition of the small direction arrows above the direction key.
RECALL MEMORY A + A ]
LIST OF NAMES E - 4 ] Enters the recall memory, list of names, programming and
SERV MODE PROG E - MN ] E-Procedures .
RUN OPER PROG E - F ]
8/12 Functions E+1 ] These functions can also be accessed directly with the key combinations
PUK Pulse chain E+2 ] shown in each line.
AZ Accel. times E+3 ]
NAM Name allocation E+4 ]
x NUM Number allocation E+5 ]
See the chapters “Recall memory and list of names”,
BZ Decel. times E+6 ] “E-Procedures” and “Programming” for the actual procedures!
M/D Permanent/Latching E+7 ]
RUB Memory depth E+8 ]
ABK Momentum curve E+9 ]