ZIMO MX31, Инструкция по эксплуатации

Страница: 15 / 29

MX31 Cab, MX31FU Radio Cab Page 15
The accessory addresses linked in the
EXPERT mode are equally valid in the
OPERATOR mode !
SWI display in EXPERT mode SWI display in OPERATOR mode
linked to a second accessory address linked to a second accessory address
Breaking such a link (deleting a linked secondary accessory address) is also possible only in the
EXPERT mode with the soft key ”2.-DEL”.
Use of Soft Key’s
The applicable assignments of the soft key’s I, II and III are indicated in the lower right corner of the
EXPERT mode display. This is by default the switchover to the OPERATOR mode, switching be-
tween the recall memory preview lists LOCO, SWI and more; see previous pages.
Soft keys can also be defined for other functions, via the menu, which are displayed accordingly at
the proper time in the display; i.e. switching of selected turnouts in the LOCO as well as in the SWI
mode.
The soft key assignment may be extended to 10 levels. For example: each soft key can control up to
10 turnouts for a total of 30. The 30 available slots may also be mixed for different functions. Moving
between the levels is done with the scroll wheel whereby the available levels are added automatically
to the recall memory preview lists that are displayed in the EXPERT mode.
Scroll to the end of the preview
list using the scroll wheel to
select from the soft key levels.
LOCO display in EXPERT mode LOCO display in EXPERT mode
with LOCO recall memory preview with the same preview list after scrolling down.
If the cursor points to an entry such as “Soft SWI Lev 1”, “Soft SWI Lev 2” at the end of the preview
table, the turnouts belonging to this level can be operated immediately with the soft keys.
11. LOCO and SWI handling
in
Guest
Mode
GUEST- Mode from SW-Version 1.12 !
The GUEST mode can only be selected via the menu (LOCO or SWI menu). Press the soft key “M”,
scroll to GUEST mode, select with the “A” key and exit the menu with the “E” key.
First applications (turnout actuations with soft keys) from SW-Version 1.10!
LOCO display – OPERATOR MENU after GUEST selection LOCO display – GUEST
A number of functions are locked out in the GUEST mode:
Deactivation, which includes address input,
Activation of modules such as MX9, MXDS,
Switch ladders, AOS etc.,
Recall memory list, list of names, menus,
E-functions,
Programming in service mode (E+MAN) as well as operations mode (E+F, E+W),
EXPERT mode,
Keys C, T, RG
NOTE and TIP: It is still possible though in the GUEST mode to switch to the next loco address or
the next group of switches with the keys F or W, provided the recall memory of the cab holds more
addresses. If the GUEST mode is to be limited to one address only, delete all other addresses from
the cab before entering the GUEST mode!
The GUEST mode can be exited with the help of the soft key III, but only after entering a secret
code number (PIN)! By default, this number is 0 and is therefore not necessary to enter when
prompted to do so (just acknowledge with the “A” key).
An actual secret code number that needs to be entered before exiting the GUEST mode can be de-
fiend under PIN in the menu ABOUT THIS CAB.
In case the defined number was forgotten, a master code number can be obtained from ZIMO.