7
CAUTION
Notes and handling regulations for electrostatically sensitive components
Electrostatically sensitive components are individual components, integrated circuits or assemblies that can be
damaged by electrostatic fields or electrostatic discharge.
►
When handling electrostatic components, make sure that persons, the work area and packaging are all fully
grounded.
►
Touch electronic components only in appropriately identified areas with conductive flooring and only if:
• You are grounded by means of special bracelets.
• You wear shoes that are suitable and approved for the discharge of electrostatic charges.
►
Do not bring electronic assemblies into contact with plastics and parts of clothing that have plastic content.
►
Store electronic assemblies on conductive underlays only.
►
Do not install electronic assemblies in the vicinity of data back-up devices or monitors (monitor distance >
100 mm).
►
Perform measurements on electronic assemblies only if:
• The measuring instrument is grounded (e.g. via a ground conductor).
• The measuring head is momentarily discharged before measuring with a floating measuring instrument.
3 Proper use
NOTICE
The product is only to be used in its original state with its original accessories, with no unauthorized changes and
within the stipulated parameter limits and operating conditions.
Any other or secondary use is deemed improper.
►
Operate the product only in compliance with the associated installation and operating instructions.
►
Operate the product only when it is in a technical condition that corresponds to the guaranteed parameters
and operating conditions.
Ö
Zimmer GmbH shall accept no liability for any damage caused by improper use. The operator bears sole
responsibility.
The product is designed exclusively for electric operation using a 24 V DC power supply.
The product is intended for industrial use.
The product is used as defined under "Proper use" in enclosed rooms for temporarily gripping, handling and holding
workpieces in human-robot collaboration.
The pre-assembled gripper fingers are designed for outside gripping as the closed and rounded surfaces faces inward. For
inside gripping of the product, the gripper fingers must be mounted backwards to ensure safe operation and so that the
rounded surfaces face outward.
The product is not suitable for clamping workpieces during a machining process.
Direct contact with perishable goods/food is not permitted.
4
Personnel qualification
Installation, commissioning and maintenance may only be performed by trained specialists. These persons must have read
and understood the installation and operating instructions in full.
INSTALLATION AND OPERATING INSTRUCTIONS:
HRC-07
DDOC01015 / a
EN / 2022-07-20
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com