INSTALLATION AND OPERATING INSTRUCTIONS:
2-jaw parallel gripper, electric, GEP9000 series
5
DDOC00190 / c
EN / 2020-02-03
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
+49 7844 9138 0
●
+49 7844 9138 80
●
www.zimmer-group.com
3. Proper use
NOTICE:
The gripper is to be used only in its original state with its original accessories, without any unautho-
rized changes and within the scope of its defined parameters of use.
Zimmer GmbH shall accept no liability for any damage caused by improper use.
Use outside of the defined parameters is not permitted. Unauthorized electrical or mechanical modifications must not
be made.
The gripper is designed exclusively for electric operation using a 24 V power supply.
The gripper is designated for use in enclosed rooms for temporarily gripping, handling and holding parts.
The gripper is not suitable for clamping workpieces during a machining process.
Direct contact with perishable goods/food is not permitted.
4.
Personnel qualification
Installation, commissioning and maintenance may only be performed by specialists. These personnel must have read
and understood the installation and operating instructions in full.
5. Product description
5.1 Forces and torques
INFORMATION:
For information on forces and torques, please visit our website.
Zimmer Customer Service is available to provide you with assistance if you have any further ques-
tions.
5.2 Type plate
A type plate is attached to the housing of the gripper.
The serial number and the article number are shown on this type plate.
►
The serial number should be assigned to the project.
Ö
Article number:
dl
Ö
Serial number:
dm
INFORMATION:
Please state the serial number in the event of damage or a complaint.
Zimmer Customer Service is available to provide you with assistance if you have any further ques-
tions.
