Z16FMC Series Motor Control Development Kit
Quick Start Guide
QS007901-1110
Page 8 of 15
Windows XP
Observe the following steps to install the USB Smart Cable for Windows XP systems.
1. Connect the Zilog USB device to the Host PC. The
Found New Hardware
Wizard
should activate automatically after connecting the Zilog USB device for the first time;
Select
No, not at this time
if asked to connect to Windows
®
Update.
2. Select
Install from a list or specific location (Advanced)
and click
Next
.
If the Windows Logo testing dialog appears, select
Continue Anyway
.
3. Select
Search for the best driver in these locations
and
Include this location in
search:
.
4. Browse to the following directory and click
Next
:
<ZDS installation>\device drivers\USB\X32
5. Click
Next
after the appropriate driver information is found.
6. Click
Finish
to complete the installation.
Step 4. Connect the Opto-Isolated USB Smart Cable to the
MC MDS Board
Attach one end of the six-conductor ribbon cable (included) to the opto-isolated USB
Smart Cable’s six-pin DBG connector. Pin 1 of the ribbon cable is indicated by a dark
stripe (see Figure 3).
Attach the free end of the ribbon cable to the DBG connector on the MC MDS board.
Note:
