Copyright ©2010 Zilog
®
, Inc. All rights reserved.
www.zilog.com
Introduction
This quick start guide describes how to set up Zilog’s ZNEO™ Z16FMC Series Motor
Control Development Kit and use it to evaluate your motor control designs and applica-
tions.
The Z16FMC Series Motor Control Development Kit features a Motor Control Modular
Development System (MC MDS) daughter board mounted on a 3-Phase Motor Control
Application Board (see Figure 1). The MC MDS board consists of a 64LQFP Z16FMC
chip and a DBG connector to connect the kit to a host development PC via the USB Smart
Cable. The 3-Phase Motor Control Application Board provides spade lug connectors for
the 3-phase motor and fused spade lug connectors for an adjustable 24 V DC, 3 A work-
bench power source.
This document guides you through the following elements:
•
Power supply requirements to power the 3-phase motor supplied with the kit
•
How to run the kit’s preloaded sample code in standalone mode
•
How to connect the kit to your development PC
•
Running the sample code in Zilog Developer System II (ZDS II) Debug mode
Kit Contents
All hardware (except an external adjustable power supply) and software/documentation
required to evaluate the Zilog
®
motor control solution is included within the Z16FMC
Series Motor Control Development Kit. For details on kit contents, refer to the Z16FMC
Series Motor Control Development Kit Packing List (PAK0025). The sample code used in
this development kit is based on the Zilog Application Note titled
Sensorless BLDC Motor
Control Using the ZNEO Z16FMC MCU (AN0311)
. The latest sample code for this docu-
ment, AN0311-SC01, can be downloaded at
www.zilog.com
.
System Requirements
Table 1 lists the system requirements for running ZDS II.
Z16FMC
™
Series Motor Control
Development Kit
Quick Start Guide
QS007901-1110
